GAI-Tronics Auteldac 5, Installation And User Manual

Page: 10 / 36

9 Auteldac 5
3.3.2 Pole-side Mounting
Kit No 100-02-0208-001
This accessory kit is for mounting GAI-Tronics telephones on to the side
of round poles of 100mm to 200mm diameter, or on to square or
rectangular section uprights of 100mm to 150mm across the mounting
surface. For flat mounting on surfaces greater than 150mm across use
the wall mounted method.
Pole side mounting
NOTE:
Banding straps (large scale worm-drive clamps) are not included in this
kit and must be obtained separately. For details of where mounting kits
can be obtained, refer to GAI-Tronics .
1. Remove rubber feet from the Rear Casing if fitted. Attach the pole
mounting clamp assemblies to the Rear Casing using the M6 x 25
screws provided. Tighten to a torque of 4.5Nm max.
IMPORTANT: avoid the use of power tools. Spinning the nuts too
quickly can cause a rapid increase in heat which can cause the nuts
to seize as a result of galling or cold-welding.
2. Ensuring that the glands are at the bottom, pass a proprietary
banding strap round each of the pole mounting clamps and the
support pole. Tighten securely.
3. Remove the terminal cover to allow access to the cable glands and
terminals. Retain the cover to refit prior to putting the telephone into
use.
4. Continue the installation procedure with the connection of individual
wires from the cable as described under sections 3.4 onwards.
5. Secure the telephone Front Casing to the Rear Casing.
6. Re-tighten the straps firmly and trim off any excess band material.
For security the driving head of the band may also be sawn off.