Pub. 42004-556A
IP Controller
Page 6 of 8
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-556A.docx
01/21
600-ohm Audio I/O with Control
Audio Input
The IP controller has a 600-ohm audio input. Enable the audio input via the closure of a dry contact input
control:
1.
Connect the 600-ohm audio input wires to connector
P1
; pins 9, 10, and shield.
2.
Connect the input control contact to connector
P1
; pins 3 and 4.
Audio Output
The IP controller has a 600-ohm audio output to send audio to remote equipment. A solid-state relay
contact activates the remote audio equipment’s input when the audio output is active:
1.
Connect the 600-ohm audio output wires to
P1
pins 6, 7, and 5 (optional shield).
2.
Connect the output contact to
P1
pins 1 and 2.
API (Access Panel Interfaces)
The IP controller is compatible with
Elemec3
IP access panels. Refer to the
Elemec3
IP access panel
manual included with the
Elemec3
system for information on installation, operation, and maintenance of
the installed
Elemec3
IP access panels.
Inputs/Outputs
The IP controller has eight unsupervised inputs and eight outputs to initiate events in the system (see
Figure 3).
Connect each input between common (
P3
pin 1 or 10) and the associated input; one through eight (
P3
pin 2 to 9), on connector
P3
.
Connector
P2
contains eight, open-drain outputs (see
1.
Connect each output device between the
+
terminal of the (
customer supplied
) power supply
and the desired output contact (
P2
pins 2 through
9).
2.
Connect the
−
terminal of the power supply to
common (
P2
pin 1 or 10) on the controller.
The IP controller is compatible with
Elemec3
IP
MIMs (monitored input modules) and MRMs
(monitored relay modules). Refer to the
Elemec3
IP
MIM/MRM manual, included with the
Elemec3
system, for information on installation, operation,
and maintenance of the installed
Elemec3
IP
MIM(s)/MRM(s).
Configuration
Custom configure the IP controller for its intended purpose using the E3 Console application. Refer to
GAI-Tronics Pub. 42004-550 for E3 Console software user instructions (see the Reference
Documentation section).
Figure 6. Output Device Connections (
P2
)
