Gaggia Brera, Operating Instructions Manual

Page: 23 / 88

• 23 •
4 Make sure the selector switch is in the
“ ” position.
5 Press and hold the 2 brew buttons at the
same time for 3 seconds: the descaling
cycle is started.
Note: if the “ ” and “ ”
indicator lights start blink-
ing immediately after start-up, turn
the selector switch right to the “
”
position. When the “ ”, “ ” and
“ ” indicator lights start blinking,
turn the selector switch back to the
“ ” central position.
6 The “ ” light blinks to show the
machine has entered the descaling
automatic programme; when the
“ ” light is steady, the 1
st limescale
removal phase is on.
8 The “ ” light blinks to show the
machine has entered the descaling
automatic programme; when the
“ ” light is steady, the 1
st limescale
removal phase is on.
7 When the “ ” and “ ” lights start
blinking, turn the selector switch
clockwise to the “
” position; in this
case, the steam/hot water wand starts
dispensing the descaling solution at
regular intervals.
9 When there is no more descaling solu-
tion left in the water tank, the “ ” ,
“ ” and “ ” lights blink simul-
taneously.
12 Remove the water tank, rinse it and
fi ll it up to the “MAX” level with fresh
drinking water.
11 The “ ” light turns on and the water
tank must be removed before entering
the next stage.
13 Place the tank back in the machine. The
two “ ” lights turn on showing the
machine has entered the rinse phase.
The “ ” and “ ” lights are blinking
in the display.
14 Place an empty container under the
steam wand and another one under
the dispensing spout.
Turn the selector clockwise to the “ ”
position.
10 Turn the selector switch to the “ ”
central position.
Empty the container under the steam
wand and the one under the dispensing
spout.