Installation instructions
en
41
3.
Note the colours of the cables.
– BN: Brown
– BU: Blue
– GN/YE: Green and yellow
– BK: Black
– GY: Grey
4.
Depending on the type of connection, change the
arrangement of the terminals supplied by the fact-
ory, if required.
‒
For this, if required, shorten the clamps and re-
move the insulation in order to insert a clamp
that connects the 2 cables.
26.18 Checking the functionality
1.
Switch on the appliance.
2.
If , or lights up, the appliance is not
connected correctly.
‒
Disconnect it from the power supply and check
the power cord connection.
→
"Establishing the power supply", Page 40
3.
If no faults appear on the appliance's display, use
the operating instructions to check that the appli-
ance is working.
26.19 Sealing the joints
For flush installation, seal the joints with silicone.
Requirement:
You must carry out a function test before
sealing any joints.
1.
Seal all around the gap using suitable, heat-resistant
silicone, e.g. Novasil® S70 or Ottoseal® S70.
Unsuitable silicone adhesive causes permanent dis-
coloration to natural stone worktops.
2.
Use the smoothing agent recommended by the
manufacturer to smooth the joint.
3.
Observe the usage instructions for the silicone ad-
hesive.
4.
Leave the silicone adhesive to dry for at least 24
hours.
The drying time depends on the ambient temperat-
ure.
5.
Do not operate the appliance until the silicone has
dried completely.
26.20 Removing the appliance
WARNING ‒ Risk of electric shock!
When disconnecting the appliance from the power sup-
ply, the terminals may cause reverse voltage.
▶
The electrical connection must only be carried out
by licensed specialist staff.
ATTENTION!
Tools may damage the appliance frame.
▶
Do not prise out the appliance from above.
1.
Disconnect the appliance from the power supply.
2.
Remove the silicone joint.
3.
Push out the appliance from below.
