21
Basic settings
en
Suitability test of tableware
This function can be used to check the speed and
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
1
Fill the pan with approximately 200 ml water and
place it at room temperature in the middle of the
hotplate that most closely matches the diameter of
the pan base.
2
Go to the basic settings and select the
™„
setting.
‹””
will be lit.
3
Touch the
@
or
A
symbol.
‹¯
will be lit. A signal
tone will sound and the hotplate indicators will be
lit.
The function has now been activated.
¥—¯
will be lit. After a few seconds, the hotplate
displays will show the results for the quality and speed
of the cooking process.
Check the result using the following table:
To activate the function again, select the
@
or
A
symbol.
Notes
–
Do not use the wok or wok accessories with this
function.
–
The Flex cooking zone is set to function as a single
hotplate; only test one item of cookware at a time on
it.
–
If the diameter of the hotplate that is used is much
smaller than the diameter of the cookware, only the
middle of the cookware can be expected to heat up.
This may result in the cooking results not being as
good as expected or being less than satisfactory.
–
You can find information on this function in the
section entitled
~
"Basic settings"
–
You can find information on the type, size and
positioning of the cookware in the sections entitled
~
"Cooking with induction"
and
~
"Flexible
cooking zone"
.
Result
‹
The cookware is not suitable for the hotplate and will
therefore not heat up.*
‚
The cookware is taking longer to heat up than expected
and the cooking process is not going as well as it
should.*
ƒ
The cookware is heating up correctly and the cooking
process is going well.
* If there is a smaller hotplate available, test the cookware
again on the smaller hotplate.
