Fault, what to do?
en
35
Refill indicator for salt
P
and/
or rinse-aid
H
is not lit.
Refill indicator switched off.
Activation/deactivation (see chapter “Water
softening system/Special salt” or “Rinse
aid” ).
There is still enough special salt/
rinse aid available.
Check refill indicator, levels.
Water is left in the appliance at
the end of the programme.
Filter system or area under the filters
1Z
is blocked.
Clean filters and area underneath.
Program has not ended yet.
Wait until programme ends or reset.
Utensils not dry.
No or too little rinse aid in the
dispenser.
Refill rinse aid.
Programme selected without drying.
Select programme with drying.
Water collecting in depressions on
the utensils and cutlery.
Arrange utensils in a sloping position,
arrange affected utensils as sloping as
possible.
The combined detergent used has
a poor drying performance.
Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
ExtraDry to increase drying not
activated.
Activate ExtraDry.
Utensils were removed too early or
drying process had not ended yet.
Wait until program ends or wait until 30 min
after program ends before removing
utensils.
The eco rinse aid used has a limited
drying performance.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Door does not open automatically at
the end of the Eco 50° programme.
Door gap is not set correctly.
Set the door correctly with the aid of the
installation instructions so that the door gap
is min. 70 mm - 150 mm.
Plastic utensils not dry.
Special properties of plastic.
Plastic has a lower heat storage capacity
and therefore dries less well.
Cutlery not dry.
Cutlery not arranged properly in the
cutlery basket.
Separate cutlery if possible, prevent contact
points.
Cutlery not arranged properly in the
cutlery drawer.
Arrange cutlery properly and separate if
possible.
Appliance interior wet after rinse
cycle.
No appliance fault.
On account of the “Condensation drying”
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.
Fault
Cause
Remedial action
