Fault, what to do?
en
43
Home Connect cannot be
implemented correctly.
Possible setting errors or a technical
fault.
Observe the supplied documents and
support information for Home Connect.
Energy manager does not
connect to the energy manager
of the home system. *
Connection to the energy manager of
the home system is not available.
Refer to the instructions for use from the
energy manager manufacturer for your home
system.
Refill indicator for salt
P
and/
or rinse aid
H
is lit.
No rinse aid.
Refill rinse aid.
No salt.
Refill with special salt.
Sensor does not detect salt tablets.
Use different special salt.
Refill indicator for salt
P
and/
or rinse aid
H
is not lit.
Refill indicator switched off.
Activation/deactivation (see chapter “Water
softening system/Special salt” or “Rinse
aid” ).
There is still enough special salt/
rinse aid available.
Check refill indicator, levels.
The Machine Care display lights
up. *
Machine Care is recommended.
Run the Machine Care programme using a
special dishwasher cleaning agent and
without loading any utensils.
The display will go out automatically after
three wash cycles whether or not the
Machine Care programme is carried out.
Water is left in the appliance at
the end of the programme.
Filter system or area under the filters
1j
is blocked.
Clean filters and area underneath.
Programme has not yet finished
Wait until programme ends or reset.
Utensils not dry.
Not enough rinse aid in the
dispenser, or none at all.
Refill rinse aid.
Programme without drying was
selected.
Select programme with drying.
Water collecting in depressions on
the utensils and cutlery.
Arrange utensils in a sloping position,
arrange affected utensils as sloping as
possible.
The combined detergent used has a
poor drying performance.
Use different combination detergent with
better drying performance. Use of rinse aid
also improves the drying performance.
ExtraDry to increase drying not
activated.
Activate ExtraDry.
a
"extraDry" on page 34
Utensils were removed too early or
drying process had not ended yet.
Wait until the programme ends, or wait until
30 minutes after the end of the programme
before removing the utensils.
The eco rinse aid used has a limited
drying performance.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Plastic utensils not dry.
Special properties of plastic.
Plastic has a lower heat storage capacity
and therefore dries less well.
Cutlery not dry.
Cutlery not arranged properly in the
cutlery basket.
Separate cutlery if possible, prevent contact
points.
Cutlery not arranged properly in the
cutlery drawer.
Arrange cutlery properly and separate if
possible.
Fault
Reason
Remedial action
* depending on the configuration of your specific dishwasher
