en
Troubleshooting
62
Fault
Cause and troubleshooting
Excessive formation of
foam occurs.
Detergent or appliance care product used causes ex-
cessive foaming.
▶
Change the brand of detergent.
Fault
Cause and troubleshooting
Connection to home
network is not estab-
lished.
WLAN on router is not active.
▶
Check the wireless network connection of your
router.
WLAN display is flash-
ing.
Connection to home network is not available.
▶
Activate the wireless network connection on your
router.
Home Connect cannot
be implemented cor-
rectly.
Home Connect set incorrectly.
▶
Please consult the documents supplied for
Home Connect.
Technical fault is present.
▶
Please consult the information about support in the
documents supplied for Home Connect.
Fault
Cause and troubleshooting
Special salt refill indic-
ator lights up.
Insufficient special salt.
▶
Add Special salt →
Sensor does not detect special salt tablets.
▶
Do not use special salt tablets.
Refill indicator for spe-
cial salt does not light
up.
Water softening system is switched off.
▶
Setting the water softening system
Refill indicator for
rinse aid lights up.
Insufficient rinse aid.
1.
Add Rinse aid →
.
2.
Set the amount of rinse aid to be dispensed.
→
"Setting the amount of rinse aid", Page 35
Refill indicator for
rinse aid does not
light up.
Rinse aid system is switched off.
▶
Set the amount of rinse aid to be dispensed.
Fault
Cause and troubleshooting
Water is left in the ap-
pliance at the end of
the programme.
Filter system or area under the filters is blocked.
1.
.
2.
.
Programme has not yet ended.