aus
Fault, what to do?
28
Fault table
Fault
Cause
Remedial action
Error code
“
:
‹ˆ
is lit.
Intake opening (on right inside of
appliance) covered by utensils.
Arrange utensils so that the intake opening
is not obstructed.
Error code
“
:
‚ƒ
is lit.
Heating element calcified or soiled.
Clean appliance with dishwasher cleaning
agent or descaler. Operate the dishwasher
with water softening system and check the
setting.
Error code
“
:
‚‰
is lit.
Supply hose kinked.
Install supply hose without kinks.
Tap turned off.
Turn on the tap.
Tap jammed or calcified.
Turn on the tap.
Flow rate must be min. 10 l/min. when water
supply is open.
Filter in the water supply blocked.
Switch off the appliance and pull out the
mains plug. Turn off the tap. Unscrew water
connection.
Clean filter in the supply hose. Screw water
connection on again. Check for leaks.
Reconnect power supply. Switch on the
appliance.
Error code
“
:
ƒƒ
is lit.
Filters
1R
are soiled or blocked.
Clean filters.
Error code
“
:
ƒ…
is lit.
Waste-water hose kinked or blocked. Install hose without kinks, remove any
residue.
Siphon connection still sealed.
Check connection to siphon and open if
required.
Cover on the waste water pump
loose.
Lock cover correctly.
Error code
“
:
Ġ
is lit.
Waste water pump blocked or cover
on the waste water pump is not
locked in position.
Clean pump and lock cover correctly.
Error code
“
:
ƒˆ
is lit.
Mains voltage too low.
Not an appliance fault, have the mains
voltage and electrical installation checked.
A different error code is
indicated on the digital display.
(
“
:
‹‚
to
“
:
„‹
)
A technical fault has probably
occurred.
Switch off appliances with the ON/OFF
switch
(
. After a short time restart the
appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the error
code.
Refill indicator for rinse-aid
H
is lit.
No rinse aid.
Refill rinse aid.
Refill indicator for rinse-aid
H
is not lit.
Refill indicator switched off.
Activation/deactivation.
There is still enough rinse aid
available.
Check refill indicator, levels.
Water is left in the appliance at
the end of the programme.
Filter system or area under the filters
1R
is blocked.
Clean filters and area underneath.
Program has not ended yet.
Wait until programme ends or reset.
