Operating the appliance
aus
23
Infolight *
infoLight
* depending on the features of your dishwasher
While the programme is running, a light spot shines
on the floor under the appliance door. Do not open the
appliance door until the light point is no longer visible
on the floor. If the appliance door is not completely
closed, the light spot flashes *. If the appliance
is installed at eye-level, with flush furniture front,
the light point is not visible. You can switch the Infolight
on or off.
Changing start programme *
Changing start programme
* depending on the features of your dishwasher
You can change the “Start programme” setting.
Tone volume*
Tone volume
* depending on the configuration of your specific
dishwasher
The end of the programme is indicated by a buzzer. You
can also change this setting.
Button volume
When you are operating the dishwasher, a signal
sounds whenever a button is pressed. You can control
the volume of the signal. If you do not like the button
volume, you can switch it off.
Child-proof lock *
Child-proof lock
* depending on the features of your dishwasher
The dishwasher features an electronic child-proof lock.
The child-proof lock protects children from potential
hazards which the dishwasher poses.
You can switch the child-proof lock on or off. When the
child-proof lock is on, it is difficult to open the door.
Greeting
When you switch on the dishwasher, the brand logo
appears. You can switch off the brand logo.
Factory setting
You can reset all settings to the factory setting.
Switching on the appliance
1.
Turn tap fully on.
2.
Switch on ON/OFF switch
(
.
The displays for the last programme and last
additional function selected flash. These settings will
be retained unless another
0
programme key is
pressed.
3.
Press the START button
h
.
Programme sequence starts.
Time preselection
You can delay the start of the programme by up to 24
hours. Depending on the setting of the time display, the
end of programme is indicated with “Finish in” (for
example 3h 25m) or “Finish at” (for example 15:20
hours).
1.
Open the door.
2.
Switch on ON/OFF switch
(
.
3.
Selects programme
0
.
4.
Press time preselection button
X
.
5.
Keep pressing the setting buttons
+ -
P
until the
displayed time corresponds with your requirements.
6.
Press START button
h
, timer programming is
activated.
7.
To delete the time preselection, press START button
h
for approx. 3 seconds.
Time preselection was terminated.
8.
Close the door.
Programme end
* The programme has ended when “Finished” is
indicated on the display window at the top
@
and on
the front display *
)2
.
* The end of the programme is displayed on the floor –
provided the optical display is switched on and is
visible.
* depending on the features of your dishwasher
