aus
Operating the appliance
22
Time display
The running time is determined during the programme
by the water temperature, the number of utensils as well
as the degree of soiling and may vary (depending on the
selected programme). You can change the time display
in time or hours/minutes so that the remaining running
time of the rinsing progamme appears in the display
window “Ready at” (for example 15:20 hours) or “Ready
in” (for example 3:25).
Sensor setting
The programme sequence is optmised in Auto
programmes with the aid of sensors. The sensors adjust
the programme strength of Auto programmes depending
on the amount and type of soiling. You can adjust the
sensitivity of the sensors in 3 stages.
Standard:
This setting is ideal for a mixed load and
heavily soiled utensils, but also saves energy and water.
Sensitive:
This setting adjusts the programme strength
for the effective removal of food remnants, even if the
amount of soiling is low. The energy and water
consumption is adjusted accordingly.
Very sensitive:
This setting adjusts the programme
strength for difficult conditions of use, for example
firmly dried on food remnants. This setting is
recommended if using biological or eco detergents
which contain lower amounts of active agents. The
energy and water consumption is adjusted accordingly.
extraDry
The final rinse uses a higher temperature which
improves the drying result. The running time may
increase slightly. (Caution if utensils are delicate!) You
can switch the extraDry function on or off.
Eco forecast
When Eco forecast is activated, the average water and
energy consumption of the selected programme is
briefly displayed on the display window at the top
@
.
AutoPowerOff
(Switching off automatically after the
end of the programme)
Auto Power Off
To save energy, the dishwasher is switched off 1 minute
after the programme ends. You can also change this
setting.
Possible settings are:
▯
off:
The appliance does not switch off automatically.
▯
After one minute:
The appliance switches off after 1
minute.
▯
After two hours:
The appliance switches off after 2
hours.
Note:
Note that for the settings "After one minute" and
"After two hours", the interior lighting
1"
is switched
off. To activate the interior lighting, press the ON/OFF
switch
(
.
Emotion Light *
Emotion Light
* Depending on the features of your dishwasher
You can switch the Emotion Light
1"
on or off.
Notes
▯
Depending on the setting of the automatic switch-off
function, the interior lighting is either switched on or
off.
▯
Note that the interior lighting is automatically
switched off after 1 hour when it is switched on and
the door is open.
Front display *
Front display
* depending on the features of your dishwasher
You can switch the front display
)2
on or off
(additional programme information).
Remaining time projection (Optical
display while the programme is
running) *
Remaining time projection
* depending on the features of your dishwasher
While programme is running, an optical display
(additional programme information) is indicated on the
floor under the appliance door. If the base panel is
pulled forwards or if the appliance is installed at eye-
level with flush furniture front, the display is not visible.
You can switch the optical display on or off.
