Gaggenau CI 292, Instruction Manual

Page: 31 / 36

31
What to do in the event of a fault
Usually, faults are small matters that are easy to
eliminate. Please read the information in the table
before calling the after-sales service.
Notes
‒ If
“
appears in the display, the sensor for the
relevant hotplate must be pressed and held in order
to read the fault code.
‒ If the fault code is not listed in the table, disconnect
the hob from the power supply, wait 30 seconds
and connect it again. If the display appears again,
contact technical after-sales and tell them the
precise fault code.
Display Possible cause Solution
None The power supply has been disconnected. Use other electrical devices to check whether a short-
circuit has occurred in the power supply.
The device has not been connected in
accordance with the circuit diagram. Ensure that the device has been connected in accord-
ance with the circuit diagram.
Electronic fault. If the fault cannot be rectified, inform the technical after-
sales service.
A signal sounds The control panel is damp or an object is
covering it. Dry the control panel or remove the object.
”ƒ
The electronics have overheated and have
switched off the corresponding hotplate. Wait until the electronics have cooled down sufficiently.
Then touch any symbol on the hob.
”…
The electronics have overheated and have
switched off all hotplates.
Ӡ
+ heat setting and audi-
ble signal
There is a hot pan in the area of the control
panel. There is a risk that the electronics
will overheat. Remove the pan. The fault display goes out shortly after-
wards. You can continue cooking.
Ӡ
and audible signal There is a hot pan in the area of the control
panel. To protect the electronics, the hot-
plate has been switched off. Remove the pan. Wait a few seconds. Touch any con-
trol. If the fault indicator goes out, you can continue
cooking.
”‚
/
”‡
The hotplate has overheated and switched
itself off to protect the work surface. Wait until the electronics have cooled down sufficiently
and switch the hotplate on again.
”‹
You cannot activate the settings transfer
function. Check the fault display by touching any control. You can
cook as usual without using the settings transfer func-
tion. Contact the technical after-sales service.
”‰
The hotplate was operating for an
extended period without interruption. The automatic safety switch-off function has been acti-
vated. See section
~
"Automatic safety cut-out"
“Š‹‹‹
“Š‹‚‹
The supply voltage is faulty; outside of the
normal operating range. Contact your electricity provider.
“Š‹‚‚
The hob is not connected properly Disconnect the hob from the power supply. Ensure that
it has been connected in accordance with the circuit
diagram.
š“
Demo mode is activated Disconnect the hob from the power supply. Wait
30 seconds and reconnect it. Touch any touch control in
the next 3 minutes. Demo mode is deactivated.
Do not place hot pans on the control panel.