7.
Slide the extractor hood into the on the side of
the support frame (Note: take care not to trap
the mains connecting cable) and
immediately
secure the hood with 4 screws
(Fig. 25).
8.
Screw the cover plate back on the rear of the
support frame. The cover plate is important for
the stability of the frame.
9.
Connect the air outlet pipe to the extractor hood
and to the exhaust air pipe on the ceiling (to the
circulating air switch module for circulating air
mode).
10.
Establish the electrical connection.
1
1.
Pull the protective film off the chimney’s trims
(if applicable).
12.
Avoid damaging the sensitive surfaces
when installing the ventilation ducts.
13.
Secure the top chimney duct unit which has no
magnetic strips with 2 screws on the top of the
support frame (Fig. 26).
14.
The second top chimney duct (which has
magnetic strips) should be slightly bent open, in
order to slide over the first chimney duct easily.
Adjust (leave no gap) and fix with 2 screws to
the top of the support frame (Fig. 26).
15.
Place the bottom chimney duct unit which has
no magnetic strips on the extractor hood. The
second bottom chimney duct (which has
magnetic strips) should be slightly bent open, in
order to slide over the first chimney duct easily.
Adjust to leave no gap (Fig. 27).
16.
Circulating air mode only:
insert the
activated charcoal filter (see page 10). The
activated charcoal filter is not supplied with
the appliance.
17.
T
est that the appliance functions correctly.
Note:
only dismantle the chimney ducts by hand.
Do not use a tool, this might damage the ventilation
ducts.
9000025162 en 07.04 EB
17
Fig. 25
Fig. 26
Fig. 27
Summary of Contents for AI 540-120
Page 2: ......
