240102 - RETAINING NUT STOP
200506-2 - PINTAIL TUBE
(FOR USE WITH BLIND RIVETS SMALLER THAN 5/32" Ø)
S834 - O'RING
713111 - PISTON
401115 - BACK-UP RING
403814 - O'RING
401102 - BACK-UP RING
712217 - CAP
211102 - NUT
713105 - NOSE FITTING
401089 - BACK-UP RING
712100 - HEAD CYLINDER
A-270
O'RING
S945 - O'RING
704113 - DEFLECTOR
S572 - STAT-O-SEAL (2)
402482
BUT. HD. CAP SCREW (2)
400794 - O'RING
LUBRICATING AND CLEANING PROCEDURE
HEAD
Remove nose assembly from tool before attempting disassembly of head assembly.
Remove end cap (712217). Push against threaded end of head piston (713111) to slide it out of head
cylinder (712100). Be careful not to damage threads or cause burrs on polished piston rod surface.
The re-assembly sequence is the opposite of disassembly. (See Filling and Bleeding instructions.) Apply
Loctite #242 and torque the four button-head cap screws (402479) uniformly to 40 inch lbs. to prevent
leakage around the gasket.
7
Rev. 11/06
Daily cleaning and lubrication of nose assembly will
greatly reduce downtime and increase life of
components. Using sewing machine oil, or an
equivalent cleaner/lubricant, follow instructions below.
1. Disconnect tool vacuum line (if equipped).
2. Point nose assembly into oil as shown.
3. Cycle tool 8-10 times and wipe dry.
