5
Rev. 9/11
HOW TO USE THE GB730
WARNING:
OPERATOR
MUST
READ AND UNDERSTAND ALL WARNINGS AND CAUTIONS.
WARNING:
IT IS RECOMMENDED THAT EYE PROTECTION AND HEARING PROTECTION BE WORN DURING
OPERATION.
WARNING:
DO NOT PULL RIVET IN THE AIR. PERSONAL INJURY FROM FASTENER EJECTING MAY OCCUR.
WARNING:
AIR IS EXHAUSTED FROM THE BOTTOM OF THE TOOL. DIRECT BOTTOM OF THE TOOL
(EXHAUSTED AIR) AWAY FROM OPERATOR, OTHER PERSONS WORKING IN THE VICINITY,
FOREIGN MATTER AND LIQUID.
CAUTION:
DO NOT USE BEYOND THE DESIGN INTENT.
The tool is shipped with a plastic plug in the air inlet connector. The connector has a 1/4-18 female pipe thread to accept
end-user air hose fitting.
1. Remove plastic shipping plug from Swivel (A-249) and screw in your air fitting.
2. Attach Deflector (752122) to rear of Cylinder Head Assembly (730398).
WARNING:
ROTATE DEFLECTOR AWAY FROM OPERATOR AND OTHER PERSONS WORKING IN THE VICINITY.
3. Connect air hose to tool (3/8 minimum diameter air line is mandatory, 90 p.s.i. is recommended) and cycle tool a few
times by depressing and releasing trigger. (Clean dry air is recommended.)
WARNING:
ENSURE AIR HOSE IS SECURELY CONNECTED TO AVOID POSSIBLE HOSE WHIPPING.
4. Disconnect air hose from tool.
5.
Select proper Nose Assembly and attach securely to the tool.
6.
Connect air supply.
7.
Insert rivet into Nose Assembly and the application then depress trigger. Upon releasing the trigger the stem will
eject to the rear of the tool.
DEFLECTOR
CYLINDER
HEAD
NOSE
ASSEMBLY
RIVET
WORK
RED
SHIPPING
PLUG
QUICK
DISCONNECT
FITTING
TRIGGER
Image may not reflect
actual tool
