motor, switch the suction switch off and then on again.
•
Models with battery:
if the warning led (fig. 6, ref. 2) starts flashing, it means that the
storage batteries are getting flat. After a few seconds the brushes lock to prevent
excessive unload. Load them.
At the end of work:
•
Move the tap lever (fig. 6, ref. 7) to the position “closed”;
•
Release the brush/drive lever (fig. 6, ref. 8) placed beneath the handle: the brush/drive
motor switches off and the machine stops;
•
Press the brush switch (fig. 6, ref. 3, led off) to disable the function “brush”;
•
Raising the lever (fig. 6, ref. 9), lift the scrubber from the floor to prevent the drying
blades from warping due to the continuous pressure;
•
Remove the brushes (or drive discs) to prevent them from warping permanently;
•
Depending on the model, unplug the machine or switch off the key swithc (fig. 6, ref. 1 );
•
Empty and clean the recovery tank ;
6.8
Some useful suggestions for the optimal use of the machine
If the floor presents a particularly resistant type of dirt, it is possible to make the machine
wash and dry it in separate stages.
6.8.1 Pre-washing
•
Open the water cock;
•
Set the brush switch to on;
•
Lower the head;
•
Operate the drive lever to rotate the brushes;
•
Ensure that the suction device is off and that the squeegee is raised;
•
Begin washing.
The flow of water must be dosed in proportion to the desired advance speed: the slower
the machine goes, less water comes down.
Insist on washing the dirtiest spots: in this way the detergent has the time to perform its
chemical action for the detachment and suspension of dirt, and the brushes to develop an
effective mechanical action.
6.8.2 Drying
Lower the squeegee and with the suction unit operating pass again on the same area you
have previously washed. In this way you obtain a result that is similar to a thorough
washing and the following operations of ordinary maintenance will certainly take less time.
To wash and dry at the same time, operate the brushes, water, squeegee and suction
motor simultaneously.
*
WARNING
Never leave the machine unmanned with the suction unit running.
6.9
Draining off dirty water
!
DANGER
Use the individual protection devices suitable for the operation to be performed.
Perform the draining operations with the machine disconnected from the power
supply.
The drain hose of the recovery tank is located at the rear left side of the machine.
ENGLISH
16
Summary of Contents for GT 55
