GABRIEL KERAMIK AB
12 • STUDIO
10
10
7
7
10
7
7
10
7
10
7
10
7
10
7
15
16
Assembly
Carefully centre and set the outer
rings (7). Make sure that the outer
ring is
one step ahead
of each
inner block - set without mortar -
during the assembly. Outer rings
and inner blocks must not be in
contact. Level vertically and hori-
zontally.
Check the control measurements,
see page 5.
For a better joint, wipe
the contact surfaces with
a squeezed sponge. After-
wards gently brush the
mortar joints with a wet
radiator brush.
Place the inner block (10) on top
of the firebox block
without
mortar joint
. Make sure that
this and the following blocks are
in level and do not ignore any
irregularities.
Seal/isulate the hollow space
under the outer ring as indicated.