Elnur
powered by Gabarrón | ECOMBI SSH | Installation Guide
8
3. OPERATING INSTRUCTIONS
On/Off
Once the heater is connected to a mains supply you can turn the heater ON by
switching the main ON/OFF switch positioned on the rear of the right hand side
of the heater as shown above.
Backlight
Press any button and the display will illuminate with a soft white colour.
The display back light will turn off after time if no buttons are pressed.
Programming Buttons will only respond when the back light is on.
Keyboard Lock
During any operation mode, it is possible to lock the keyboard.
You can do this by holding both the and buttons simultaneously
until the padlock indicator is displayed on the screen.
G-Control Hub
connection indicator
Daily Programming:
Temperature level for
each time interval (1h)
of the day
Button “+” Press
the key to increase
different values or
scroll through menus
Button “-” Press the
key to decrease
different values or
scroll through menus
“Config/Prog” Button
Press the button to access
the advanced configuration
and exit menu items
Open Windows
detection indicator
Keyboard lock indicator
Programme mode
indicator
“OK” Button
Press the button to check and set the time. Press
the button to confirm values in the different menus
Current charge level
Current set point in
Programme Mode
To unlock the keyboard, press the and simultaneously until the
padlock indicator disappears from the screen.
3.1 General information
Connection/Disconnection
Power switch. All models are equipped with a switch on the
back side panel. It is used to Turn On and Turn Off the ECOMBI SSH.
Keyboard:
CAUTION:
DO NOT USE THIS HEATER TO DRY CLOTHES.
Do not cover this heater at any time.
!
