Elnur
powered by Gabarrón | ECOMBI SSH | Installation Guide
4
Check that all parts have been delivered and are intact.
- 1 Ecombi SSH heater casing.
- 1 bag containing 2 screws and 2 rawl plugs.
- 2 supporting feet.
- This guide.
- 1 superior fixing fitting.
- 2 lateral fixing fitting, already installed on the heater
Turn the carton upside down to allow the heater to stand on its feet and remove the carton.
Check that it is the correct model and that it is in good conditions.
The casing and storage bricks are supplied separately. Check the supplied bricks
packages correspond to the ones indicated on the heater carton.
!
The heater operation is not affected if bricks with minor damage are used.
!
3. Take off the front panel by removing the two screws located at the bottom. Fix the lateral fittings to the
metal structure by using the appropriate screws.
4. Place ECOMBI SSH in your selected installation area. Use the heater fixing holes as a template and mark the
wall through the fixing holes with a pencil. Drill the required holes into the wall. Place the rawl plugs and screws
into the holes before the appliance installation but do not fasten them tightly.
5. Attach ECOMBI SSH to the rawl plugs with the screws. IT MUST NOT BE HUNG ON THE SCREWS; these are used
only to prevent the device from overturning and not to support it. If there is any doubt concerning the wall
strength, consult the corresponding construction specialist. The appliances are heavy; it is the installers
responsibility to ensure the correct installation and wall support of these devices to prevent them from overturning.
6. Connect the heater using the wiring diagram included at the end of this manual. Tighten properly the
connection block screws. Do not leave any remaining wire inside the heater.
Touching live connections can cause serious personal injury.
!
