Elnur
powered by Gabarrón | ECOMBI HHR | Installation Guide
3
INSTALLATION INSTRUCTIONS
The symbols used in the text are explained below:
WARNING This indication shows the possibility of causing death from electric shock.
WARNING This indication shows the possibility of causing death or serious injury.
CAUTION This indication shows the possibility of causing injury or damage to
properties only.
Symbol for useful information.
• The warranty of the heater will not cover any
damage caused by non-observance of any of
these instructions.
• The installation must be carried out in accordance
with the current IEE regulations. Any installation
or reinstallation has to be carried out by a skilled
or instructed person.
• Please check that cable, isolation switch gear and
power supply is sufficient for the voltage and watts
shown on the rating label.
• This appliance must be Earthed.
• This appliance should not be installed just below
an electrical socket.
• This appliance must be installed outside of zone 2,
the controls should not be accessible by anyone
using a bath or shower.
• If during any installation the thermal insulation shows
any sign of damage, it must be replaced.
• This heater should be switched off at the isolation
switch and/or circuit breaker before any repair work
is carried out on the heater.
• This appliance is only intended for a fixed installation
with a permanent connection and is not for portable
use. After the installation a survey of the first charge
cycle should be carried out to ensure that the main
input thermostat switches off. Ventilate the room
during this first cycle.
• Never open a charged heater; temperatures can rise
above 600°C.
• To maintain stability, it is essential that the heater
is placed on a level surface and care should be taken
to avoid irregular surfaces, such as may result from
carpets or tiled surrounds partially protruding under
the heater.
• The presence of air particles of smoke, dust, scented
candles and other pollutants, could in time, discolour
the walls and surfaces around the heater
!
!
!
IMPORTANT:
Wiring procedures and connections should be in accordance to current IEE
regulations.
!
Keep combustible materials, such as furniture, pillows,
bedding, papers, clothes and curtains at least a foot
(300mm) from the front, sides and rear of the heater.
It is essential that the indicated minimum clearances
are maintained.
Note:
Items such as shelves that are mounted above
the heater below the minimum 250mm clearance will
affect the performance of the heater.
