G-Tek Corporation Private Limited
26
7.3
F
UNCTIONS
7.3.1
System Setup
In the system setup menu, we can start new batch, stop running batch, set device address, also can
set which way to use memory and clear memory.
To set this parameter then follow the below mentioned procedure by pressing the appropriate
buttons given on the front panel of the LmNet.
7.3.1.1
Batch status (Start/Stop)
Use to start new batch and stop running batch as shown in figure-23.
Figure 22 Batch status
mEm wILL CLr
And StArt
StoP
Bch stsp
SAvE
SAvE
2 126.55
Figure 22 System Setup
Figure 23 Batch Status
bCH StSP
dEv Addr
Sys stup
mEm SEt
CLr mEm
CHng PSw
