www.g-lites.com
8
The projectors’ control signal output or input by using the 3-pin XLR pug and
socket. If need to long then the communication cable, please make sure the both
side of 3-pin plug is one to one (one to one, two to two, three to three).
Otherwise, the communication cable will be interrupted. The communicate cable
is 2-pin shielded cable 75
Ω
Resistance with each core is at least a 0.5mm diameter. (Caution: All the inside
leading wire of 3-pin XLR plug couldn't touch each other or plinth).
Recommend to use the DMX signal terminator for the installation to avoid the
electronic noise damage the digital control signal. Simply speaking, DMX
terminator is an XLR connector with a 120
Ω
/1w resistor connected across pin 2
and 3.Which is then plugged into the output socket on the last projector in the
chain. Refer to the connection as above: (Picture ). We suggest using the DMX
signal distributor when the distance of the lights over 15meter. In case of effect
the light communication because of the signal feeble.
3. Light power connection:
After doing the above operation and making sure all the projectors had been
installed with natural operate, press the power switch to check whether
everything is working normally.
