www.g-lites.com
16
4.
Please check whether the communicate cable is too long or the other
equipment is mutually conjugate.
5.
Please arrange the wire well, shorter the signal cable, put the high
voltage cable and low voltage cable separately.
6.
Add the signal amplify isolator.
7.
Signal cable is used the excellent screening doublet (Resistance 75
OHM)
8.
The end the light and the end resistance.
●
The light can't move:
1.
Please check if the power supply is suitable for the light voltage data.
2.
Please check the fuse of input voltage is defective.
3.
Please check the light if there is deformation, inside parts is broken,
become wet etc, will lead the loose contact.
14. CLEANING AND MAINTENANCE
■
1. In order to ensure the projector could work normally. It should be kept clean
always .The lens should also be regularly cleaned to maintain an optimum
light output. Do not use any type of solvent on lens. It will damage the
projector.
■
2. Suggestion: The continue usage of the light don't exceed 4 hours. Or it will
shorter the usage of the lamp. Please use the alternative operation to solve
this problem.
■
3. Please disconnect the power supply when begin to maintenance take down
the light. Please let the parts cool down 10 minute at least then begin to
install.
■
4. Please inspect the lens or other moving parts timing and keep them clear and
static. If find anything damaged or looseness must change a lamp or fix the
lamp in order to avoid the accident.
