© 2012 G Force Automatic Gates All Rights Reserved
Black / Blue
wires to
black
Negative battery Terminal /
Double piggy back spade
connectors for solar power or
single spade connectors for
transformer power.
Red
wires to
Red
Positive
Battery Terminal / Double piggy
back spade connectors for solar
power or single spade connectors
for transformer power.
DSG DC2 GATE MOTOR
INSTALLATION AND SET UP
INSTRUCTIONS
Refer to the “
DC 2 Circuit Board” ”
data sheet included with this manual or to any reference
notes or photos and fit the wires back into the correct terminal locations on the control board.
Fit the battery on its end into the battery space on the drive assembly as shown below.
Connecting the Circuit Board and Fitting the Battery
It is recommended that the battery be connected first during this stage of the installation. The
primary power source can be connected after all the necessary set-up procedures and
adjustments are made. Refer to the “
DC 2 Circuit Board”
data sheet included with this manual
and locate the battery connection terminals on the circuit board. Ensure the battery wires are
correctly connected to the correct terminals on the circuit board. Connect the battery wires to the
battery terminals on the battery. Note the polarity (
Red
positive wires to
Red
battery terminal,
Black / Blue
Negative wires to
Black
battery terminal). The board should now be powered
and great care should be taken to avoid shorting out or otherwise damaging the circuit board.
Battery Wires
Care should be taken as there are moving components inside the gate
motor that may cause damage or personal injury.
ALWAYS TURN THE POWER OFF AND DISCONNECT THE BATTERY
BEFORE MAKING ANY WIRING CONNECTIONS
Drive
Assembly
Battery
DIY Automatic Gate Kits
PH 1800 111 930
Mounting
Cradle
