26
To remove the shave plate, remove the carriage bolts and flange lock nuts which attach the
shave plate to the snow thrower housing. See above picture 10.
Reassemble the new shave plate, with heads of carriage bolts to the inside of the housing.
Tighten securely.
MAINTENANCE PROCEDURES
TIRE INFLATION
Before each use of your Snow Thrower, check the tire pressure. The pressure in each tire
should be in the range of 1.4-1.7 Bar for the best performance. The pressure can be
checked using an ordinary tire pressure gauge. Fill the tires using a small or pressure
regulated air compressor.
WARNING! DO NOT OVER-INFLATE THE TIRES.
Over-inflating could cause a tire
to burst and cause severe bodily injury.
SHAVE PLATE REPLACEMENT
Remove both skid shoes and hardware including carriage bolts and nuts which attach
shave plate to snow thrower housing. Reassemble new shave plate, making sure heads
of the carriage bolts are to the inside of the auger housing.
AUGER OR IMPELLER JAMS
WARNING! The auger and impeller rotate at fast speeds which can cause
harm or even amputation to a person's body parts. Even if you do not see the
auger or impeller rotating, it may start at any time if the engine is
running.Remove the Safety Key before cleaning the jams.The chute clean-out
tool is fastened to the upper tube with mounting clips.
1.
Always turn OFF the engine before attempting to clear any clogs or jams.
Clean-out tool
Figure 10
