FXA 501741206, Instruction Manual

Page: 14 / 62

- 14 -
NOTICE: Running the engine with a low oil level will cause engine damage.
-
Change Engine Oil
Drain the used oil while the engine is warm. Warm oil drains quickly and completely.
z
Wipe the oil filler area clean, and then remove the oil filler cap/dipstick.
z Place a suitable container next to the mower to catch the used oil, and then tilt the mower on its right
side. The used oil will drain through the filler neck. Allow the oil to drain completely.
Please dispose of used motor oil and the containers in a manner that is compatible with the environment.
We suggest you take it in a sealed container to your local recycling center or service station for
reclamation. Do not throw it in the trash, pour it on the ground, or pour it down a drain.
z
Fill with the recommended oil. Do not overfill. Allow a couple of minutes for the oil to settle in the
engine, then measure the oil level.
-
Air Cleaner Service
NOTICE:
Operating the engine without an air cleaner, or with a damaged air cleaner, will allow
dirt to enter the engine, causing rapid engine wear.
z Press down on the cover tabs and remove the cover.
z
Remove the filter from the air cleaner base.
z
Inspect the filter and foam element, and replace it if damaged.
z Clean the filter by tapping it several times on a hard surface to remove dirt, or blow compressed air
through the air filter from the inside. Never try to brush off dirt; brushing will force dirt into the fibers.
z Wipe dirt from the inside of the air cleaner base and cover, using a moist rag. Be careful to prevent
dirt from entering the air duct that leads to the carburetor.
z
Reinstall the filter and cover.
-
Spark Plug Service
For good performance, the spark plug must be properly gapped and free of deposits.
z
Disconnect the spark plug cap and remove any dirt from around the spark plug area.