Translation of original operating instructions for petrol chainsaw FX-KSP series
45
Check the rubber seal and renew if neces-
sary.
Press the filter parts together until they en-
gage audibly, insert the filter in the housing
and secure firmly with the filter screw.
Fit the filter cover again and secure with
the quick-fit clips.
Oil supply hole
Remove the guide rail.
Clean the oil supply hole (N) by suitable
means. Blow through outwards via the oil
filter with compressed air if necessary.
Guide rail oil inlet and oil outlet hole
The guide rail is removed:
Blow out the chain guide groove and front
gear ring (
Q
) with compressed air.
Clean stubborn dirt from the chain guide
groove with a rail hook (available from
specialist dealer).
Blow out oil inlet hole (
O
) and oil outlet
hole (
P
) of the guide rail with compressed air.
The oil for lubrication of the front gear ring (
Q
)
and saw chain is supplied from the oil pump
of the chainsaw.
Visual checks
Check the chainsaw for:
fuel leaks
loosen attachment parts (particularly guide
rail and saw chain)
damaged components (handles etc.)
Rectify defects before using the equipment
again.
Periodic maintenance
Fuel filter
Place the chainsaw down in a way that it
cannot tip over. No fuel should escape!
Unscrew the fuel tank cap (
1.
) and re-
move (
2.
).
With a piece of wire bent at the end, pull
out the filter insert (
3.
).
Wash the filter insert with petrol or renew if
necessary.
Perform a visual check of the cap seal and
also renew if necessary.
Insert the filter insert and screw on the cap
firmly.
Removing the spark plug
Lever off the 2 quick-fit clips on the filter
cover using a screwdriver.
Remove the filter cover.
Take out the filter.
Pull off the spark plug connector.
Unscrew the spark plug in anti-clockwise
direction with a spark plug wrench (C)
(socket).
