FUXTEC FX-KS142, Original User Manual

Page: 7 / 35

Original User Manual FUXTEC chainsaw FX-KS142_KS146_rev08
7
Pull starter with Easy Start function. To start
the device, slowly and evenly pre-tension the
start spring by pulling. No jerky pulling
necessary. Do not pull beyond the dead
centre, otherwise the cable may break
Warning: The actual existing vibration emission value during the use of the
device may differ from the value specified in the instruction manual or by
the manufacturer. This can be caused by the following factors, which should
be considered before and during use:
If the device is used correctly
• Is the way of cutting the material or how it is processed correct?
• Is the condition of use of the device in order Sharpness of the cutting
tool or correct cutting tool?
• Are the handles mounted with optional vibration grips and are firmly
attached to the device body?
All the above precautions cannot exclude the risk of white finger disease or
carpal tunnel syndrome. Long-term and regular users are therefore
recommended to closely monitor the condition of their hands and fingers.
Consult a doctor immediately if any of the above symptoms occur. If you
experience an unpleasant feeling or discoloration of the skin on your hands
while using the device, stop working immediately. Take sufficient breaks
from work. Failure to take adequate breaks can result in hand-arm vibration
syndrome.
An estimation of the degree of loading in relation to the work or use of the
device should be made and appropriate breaks in work should be taken. In
this way, the degree of stress can be significantly reduced during the entire
working time. Minimize your risk of being exposed to vibrations. Maintain
this device according to the instructions in the operating manual.
If the device is to be used frequently, you should contact your dealer and
obtain anti-vibration accessories (handles) if necessary.
Avoid using the device at temperatures of t=10°C or less. Make a work plan
to limit the vibration load.