8M083X25 R14
APX Series P25 Interface
DVRS Installation & Programming Guide
–
PART I
January 2019
Page 20 of 153
RF Energy Exposure Compliance, Awareness and
Control Information and Operational Instructions
This radio equipment is intended for use in occupational / controlled conditions,
where users have full knowledge of their exposure and can exercise control over
their exposure to meet FCC/ISED limits. This radio device is NOT authorized for
general population, consumer or any other use.
ATTENTION!
Changes or modifications not expressly approved by Futurecom Systems Group,
ULC. could void the U
ser’s authority to operate the equipment. To satisfy
FCC/ISED/IC RF exposure requirements for mobile transmitting devices, the
minimum separation distance
s specified in the “RF Safety” Book 8F083X03 (FCC)
or 8F083X05(ISED)shipped with the DVRS should be maintained. To ensure
compliance, operations at closer than this distance is not allowed.
ATTENTION!
Futurecom requires the P25 DVRS operator to ensure FCC/ISED Requirements for
Radio Frequency Exposure are met. The minimum distance between all possible
personnel and the body of the DVR
S equipped vehicle is specified in the “RF
Safety” book shipped with the DVR. Failure to observe the Maximum Permissible
Exposure (MPE) distance exclusion area around the antenna may expose persons
within this area to RF energy above the FCC/ISED exposure limit for bystanders
(general population). It is the responsibility of the repeater operator to ensure MPE
limits are observed at all times during repeater transmissions. The repeater
operator must ensure at all times that no person comes within MPE distance from
the vehicle body.
ATTENTION!
The Transportable(suitcase) DVRS ships without an APX Mobile radio. Once an
APX Mobile radio is installed, refer to the Product Safety and RF Exposure booklet
8F083X03 enclosed with your DVRS. Refer to the vehicle installation guidelines for
vehicle installation. For fixed site installation, refer to the Fixed DVRS Site
Antennas section.
