00036119.DOC, Version 1.2
24/28
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
With the POWER-switch, you can switch the device on and off.
After you connected the effect to the mains, the EYE-54 starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.
Display and function buttons
•
Press the Mode button and select from the functions:
A001 - DMX 512 Address settings:
Use the
Up
and
Down
buttons to select required address and press
Enter
to confirm or
Mode
to cancel and
return to the main menu.
RE-1 – Software version
With this function you can display the software version of the device.
PAN - Pan Reverse
With this function you can reverse the Pan-movement.
•
Press the
Mode
button and select
„PAN“.
•
Press the
Up
button to select
“y”
if you wish to enable this function or press the
Down
button to select
“n”
if you don’t.
•
Press
Enter
to confirm.
TIL - Tilt Reverse
With this function you can reverse the Tilt-movement.
•
Press the
Mode
button and select
„TIL“.
•
Press the
Up
button to select
“y”
if you wish to enable this function or press the
Down
button to select
“n”
if you don’t.
•
Press
Enter
to confirm.
DEM - Demo operation
In the Stand Alone mode, the EYE-54 can be used without controller. Disconnect EYE-54from the controller
and call up the internal program.
•
Press the
Mode
button and select
„DEM“.
•
Press the
Up
button to select
“y”
if you wish to enable this function or press the
Down
button to select
“n”
if you don’t.
•
Press
Enter
to confirm.