Tr
o
u
b
le
S
h
o
o
ti
n
g
:
Page 15 of 18 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
PD3.5 - Projector Drop Mechanism
Symptom
Cause
Remedy
Page
Emergency stop removed
Replace emergency stop
14
Remote control or batteries
faulty
Replace batteries or remote
15
Motor end stops incorrectly
set
Adjust end stop
10
Incorrect pin configuration
Terminate 8-pin RJ45 to 568/b pin
configuration
13
Faulty wiring
Replace connector or cable
13
Faulty control box
Test contact closure on control box
13
Incorrect settings
Refer to instructions
14
Incorrect pin configuration
Terminate 6-pin RJ11 to
configuration supplied
14
ASC11 protocol error
Amend Protocol
14
Lift not level
Straps not neatly stacking
Re-seat straps
11
Lift not working
Contact closure not working
RS232 not working
PD3 Projector Drop Mechanism - Trouble shooting guide
Having problems? - Check the following:
1. Are all the connections correct?
2. Is the mechanism being operated correctly?
If the mechanism does not operate correctly, check the items listed in the table below.
Should the problem persist, there may be a malfunction. If this is the case, disconnect the
mains power immediately and contact your installer.
