6) Valve Raise/Lower Switch - This toggle switch manually raises and lowers the hydraulics on your
machine. The toggle also acts as a switch when in the menu and can be used to change any param-
eter that appears in the display.
Page 3
1.
2.
3.
6
5
7
8
EG Series Control Box
Controls
(fig 1)
2) Power On/Off switch - Press the power button briefly to turn it on, and the button must be pushed
and held for approximately two seconds to turn the system off.
1) LED Grade Display - These LED’s display whether you are above grade, below grade or on
grade. The full 3 red or yellow LED arrows tell the user which direction the blade must move to
achieve on grade, while the single up or down LED will flash when the receiver is within 10mm
(0.39”) of the desired on grade. The green LED’s in the middle will flash when you are within your
desired ‘on grade’.
4) Hydraulic Indicator LED’s - These LED’s give the operator information on which valve is currently
being driven. The left LED shows valve one, the right shows valve two. The green LED shows all
valves are off
5) Auto/Manual button - This button switches the EG1 system between automatic and manual
mode when the slope display is showing. This button also gains special functions with respect to
some of the display screens shown below.
3) Menu Button - This button is used to cycle through the menu system, and will only cycle through
in one direction. If you miss the screen you’re looking for the first time through, you have to keep cy-
cling until you get to the home screen, then start again.
4
