1
4
5
6
7
11
14
8
9
10
12
13
2
3
A
?
D
?
G
?
P
Q
M
?
B
?
E
?
H
?
K
?
N
?
C
?
F
?
I
?
J
?
L
?
O
?
DESCRIPTION
TESTER
1. Video - F-connector
2. Voice - RJ11/RJ12 Jack
3. Data - RJ45 Jack
4. LCD Display
5. Data button
6. Voice button
7. Cycle button
8. Video botton
9. Tone button
10. On/Off button
REMOTE & ID’S
11. Voice - RJ11/RJ12 Jack
12. Data - RJ45 jack
13. RJ45 Remote ID (5pcs. - permit mapping 5 remote locations)
14. F-connector Remote ID (5pcs. - permit mapping 5 remote locations)
LCD DISPLAY
A. VOICE
Appears when testing or toning a phone cable.
B. DATA
Appears when testing or toning a network cable.
C. VIDEO
Appears when testing or toning a coax cable.
D. Pass
Indicates proper wiring on cable being tested.
E. Fail
Indicates wiring error on cable being tested.
F. Tone
Appears when the tone generator is activated.
G. Rev
Indicated the connections on one or more pairs.
is reversed at one of the cables.
H. Short
Indicates that two or more wires are shorted to each other
I. Volt!
Flashes when the tester is connected to a cable with voltage on
it. Exposure to voltage can damage the tester. If this warning
appears, immediately disconnect the cable from the tester.
J. X-over
Appears when the tester detects a properly wired cross over
cable.
K. Open
Appears when one or more pairs are open.
L. Battery
Indicates low battery. When this symbol appears, results from
the tester may not be reliable and the battery should be
replaced immediately.
M. Shield
Appears when the cable being tested has a shield that is
connected at both ends. The shield indicator will flash if there is
a short between the shield and any wire within the cable.
N. Split
Appears when the tester detects the signal is split between two
or more pairs.
O. ID
Appears when the tester detecs a Remote ID. Then number that
appears correspondsto the number on the Remote ID.
P. Wire map (near end) - The top row of numbers display the connector pins
on the tester end of the cable in numerical order. These pins are
mapped to the pins shown derectly below on the bottom row of
numbers.
Q. Wire map (remote end) - The bottom row of numbers displays the
corresponding pin numbers on the remote end of the cable.
Dash lines indicate shorted pins. No pin numbers indicate an
open pair.
