8
Example of setting S.BUS servo with T18MZ / T12K
3
This aircraft is equipped with four aileron servos, so it is convenient to use
S.BUS
. In advance,
decide the servo to be used and set the
S.BUS Servo setting
for each channel shown below.
This page is unnecessary when
S.BUS
is not used.
Put the name on the label and paste it on each servo.
Channel setting example when S.BUS is used: T18MZ
Channel setting example when S.BUS is used: T12K
Wing Type → 4AIL+2FLP
Tail Type → AILVATOR
AIRPLANE
WING → 4AIL+2FLP
TAIL → AILVATOR
AIRPLANE
CH1
Left
Aileron
CH6
Right
Aileron
CH4
Right
Aileron
CH5
Left
Aileron
CH12
Right
Elevator
CH2
Left
Elevator
CH3
Rudder
CH11
Throttle
CH1
Left
Aileron
CH8
Right
Aileron
CH6
Right
Aileron
CH7
Left
Aileron
CH5
Right
Elevator
CH2
Left
Elevator
CH4
Rudder
CH3
Throttle
◆Model Type
T18MZ setting
◆Model Type
T12K setting
Change to MODE Ｄ
◆CH MODE
R3008SB
In case of EP
EP:
Motor controller
connected to
CH3
port.
EP:
Motor controller
connected to
CH3
port.
Write the channel to
the servo with
S.BUS
Servo
.
！ For EP with T12K:
If model type is
4 AIL + 2 FLP
,
throttle
will be
CH11
. There is
no
CH11
output
port in the receiver (default setting), so you need to set
CH MODE
to
MODE D
and change the
receiver's
CH3
port to
CH11
output.
