6
R Required for flight (Purchase separately)
SET contents
1
2
● Exacto Knife
● Wire cutter
● Needle nose pliers
● Scissors
● Screwdriver
● Hex key
● Drill (2.2mm, 2.4mm, 4mm)
● Tape
● CA glue
● Epoxy Adhesives
● Magic Marker
● Iron
● Hook-and-Loop Tape
● Sandpaper etc.
◆ Radio
Hatch
Canopy
Cowling
Fuselage
Rudder
Horizontal stabilizer tube
Upper Wing
Bottom Wing
Aileron
Aileron
Aileron
Aileron
Main gear
Wheel ＆ Wheel pants
Horizontal stabilizer
Elevator
● Transmitter/Receiver (More than 8 channels)（e.g.
Futaba 10J, 12K, 14SG, 16SZ, 18SZ, 18MZ）
● Receiver battery（Futaba FR2F900/FR2F1800, etc.）
● Extension code
● Spinner（57 ｍｍ）
● Four stroke 70 〜 81 Engine
● Fuel tank (280 〜 400 cc)
● RC Glow fuel
● Fuel silicon tube（Nipple, fuel stopper）
● Engine starting tool (plug heat battery, booster code,
starter etc.)
● Propeller（13 × 6 〜 14 × 8）
●（8 servos）Unnecessary when servo SET
● Motor 55 in. class（Futaba FMA-5055, KV525, etc.）
● Motor controller（Futaba MC970A, etc.）
● Lipo Battery（5 cell 3,500 〜 4,500 mAh）
● Lipo charger
● Propeller（16 × 8 〜 17 × 8）
●（7 servos）Unnecessary when servo SET
EP - Motor
GP - Engine
Since this aircraft uses 4 servos for ailerons
and 2 servos for elevators,
Futaba 18MZ,
18SZ, 16SZ, 14SG, 12K
with
4 aileron
mixing
is recommended. In case of other
radio, there are cases where fine adjustment
of each servo can not be performed.
Moreover, it is convenient to use the
S.BUS
system because wiring is complicated.
