60
G
OV.
B
ASIC
M
ENU (GOVERNOR BASIC SETTING)
7KLVPHQXVHWV WKHJRYHUQRU¶V IXQGDPHQWDOIXQFWLRQV7KHPHQX6HUYR OLPLWSRLQW
VHWWLQJPXVWEHVHW¿UVW5HIHUWRSDJHDQGGLVSOD\WKH
"
*29%$6,&
"
screen from
the
"
%$6,&0(18
"
VFUHHQ
GOV. BASIC screen 1/6
From 6/6
From the
"
SBUS2 rpm Slot"
of GOV. BASIC screen 6/6
Note:
When using the governor function, be sure
to make each setting of "GOV.BASIC".
Note:
After completing the linkage of the throttle,
be sure to set the "Servo limit point setting" first,
and then set the other functions.
:
:
:
Go to 2/6 from any cursor position
(1) Governor: Governor active
Set the governor operation mode of CGY760R. The initial setting is
"ACT (active)" where , as the designation implies, the governor is active.
If you do not want to use governor, select "INH (Inhibit)" .
Setting: ACT (Active) / INH (Inhibit) Initial setting: ACT
(2) Gear Ratio:
Input the main rotor gear ratio by pushing the [ /+] or [ /-] key to select
the desired working mode.
Setting ranges: 1.00 ~ 50.00t Initial value: 8.00t
Notes:
• If the gear ratio is not properly set,
the set speed and actual engine
speed will be different.
• The gear ratio should be given in the
helicopter instruction manual. If the
helicopter instruction manual does
not give the gear ratio, calculate the
gear ratio as follows:
Rotor
main gear
N1
Engine
pinion gear
N2
Gear ratio = N1/N2
Carry values less than 1/1000 to the
next whole number.
Summary of Contents for CGY760R
Page 1: ...1M23N33702 INSTRUCTION MANUAL ...
Page 94: ......