Airplane Section
Flap Trim Authority Setting
In the Flaperon mode. Flap Trim moves both ailerons
upwards or downwards together. To input the Flap Trim
Authority, move to the next screen by pressing the NXT
R key. Then press the D key and set the rate with the
numeric keys F to M. You may choose any value from
0% to 100% for the Flap Trim Authority. The initial
setting is 30%, but a smaller number is recommended.
Flap Trim Offset Setting
Flap trim offset sets the flap position from which
motion occurs. To input the flap trim offset amount
setting, press the B key, then set the flap trimmer to the
position to be set and press the SET F key. The offset
can be anywhere between ±(trim authority setting).
Checking Your Work
After you have set up everything, be sure the controls
move the correct directions. If they do not, use the +/-
to reverse the direction as needed.
Use the END ( N) key to leave this menu, or hit PRE
to get to the previous menu.
Airplane Section, Page 90
Summary of Contents for 9ZAP - PART2
Page 78: ...Printed in Japan 990606...
