9
NOTE: If you need to remove or replace the transmitter battery, do not pull on its
wires to remove it. Instead, gently pull on the connector’s plastic housing where it
plugs in to the transmitter.
The factory default functions activated by the switches and knobs for a Mode 2
transmitter are shown below. Note that some of the functions will not operate until
activated in the mixing menus. In general, functions for a Mode 1 transmitter
reverse the E and G switches.
Switch / Knob
ACRO
GLID
HELI
Switch A
Elevator Dual Rate
Elevator Dual Rate
↓
= Butterfly on
Elevator Dual Rate
↓
= PMIX-1, 2 on
Switch B
Rudder Dual Rate
Rudder Dual Rate
Rudder Dual Rate
Switch C
↑
= ELE
→
FLP on
center/
↓
= Idle-down
↓
= Airbrake on
↑
= ELE
→
FLP on
center/
↓
= Idle-down
↓
= PMIX-5 on
CH 7
Switch D
Aileron Dual Rate
Aileron Dual Rate
Aileron Dual Rate
Switch E
Landing Gear
GLID1FLP: Gear
fwd = Throttle Hold
Switch F
Snap Roll/Trainer
Trainer
Trainer
Switch G
↓
= PMIX-5 on
back = Speed
forward = Start (Launch)
Idle-up
Switch H
↓
= PMIX-1, -2, -3 on
↓
= PMIX-1, -2, -3 on
Inverted/CH5
CH6 knob
Flap
(Flap trim if FLPRON on)
GLID1FLP: Flap
(Flap trim if FLPRON on)
GLID2FLP: Camber
(Flap trim if FLP-AI off)
Hovering Pitch
CH7 knob
Spoiler
(disabled if AI-DIF on)
Spoiler
(disabled if AI-DIF on)
Hovering Throttle
CH8 knob
CH8
CH8
CH8
Ni-Cd battery pack
PUSH
Charging jack
Battery cover
Battery connector location
Trainer function
/DSC function connector
RF module
To remove, press the tabs together
and gently pull rearwards.
To install, line up the connector pins with
the socket in the rear of the module and
gently snap into position.
