66
ELECTRICAL CONNECTIONS
Any electrical work required to install
this hob and the supply cable should be
carried out by a qualified electrician or
competent person, in accordance with the
current regulations.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any liability
should these safety measures not be
observed.
This cooker is designed to be connected to
230/400V 3N ~ electrical supply for appliances
with heating elements voltage of 230V, and
400V 3 ~ (400V 2 ~ ) electrical supply for
appliances with heating elements voltage of
400V.
To connect to the electricity supply, use cable
type H05 RR-F.
Before switching on, make sure the electricity
supply voltage is the same as that indicated on
the rating plate.
The cooker is supplied without supply cord.
The connection options for the cooker
are shown on the plate (wiring diagram) on
the rear of the cooker.
In case of a direct connection to the mains you
have to interpose an omnipolar switch a
minimum opening between contacts of 3 mm.
The switch should be sited within 2m of the hob
and be easily accessible upon completion of the
installation.
The yellow-green grounding cable has not to be
interrupted by the switch.
NOTE:
The earth wire should be about 2 cm
longer than the live and neutral wires.
•
After installation and connecting, the
cable must be placed so that it cannot at any
point reach a temperature of more than 50°C
above the ambient temperature.
supply
cable
If the supply cord is damaged, it must
be replaced by the manufacturer or its
service agent or a similarly qualified person
in order to avoid a hazard.
Before connecting check that:
•
fuse and household electric installation can
bear the charge of the appliance (see rating
plate);
•
The socket or the omnipolar switch used for
connection is easily reachable when the
appliance is installed.
How to proceed?
•
Unscrew and remove the protective cover at
the back of the appliance;
•
Connect the power cord to the terminal of the
cooker according to the wiring diagram;
•
Fix by means of cable clamp;
•
Make sure that the connection to the terminal
is matching the network power;
•
Remount and screw the protective cover at
the back of the appliance.
