Furuno VR-5020, Modification Instruction

Page: 6 / 28

6
5. How to assemble the data recorder
Insert the thermal insulator top,
noting the direction.
Set the protective ring
(24-004-1505-0)
Tie the rope with a bowknot,
being careful not to damage the
thermal insulator, set the inner
capsule in the barrel housing
using
the piece of rope.
After inserting the inner capsule,
untie the rope and fasten it with
cellophane tape.
BOTTOM
Notch
Screw hole
Center
(visible)
Screw hole TOP
*
*
Positional relation
between notch and
screw holes
Thermal
insulator
top
Projection
TOP
BOTTOM
Post
One post: TOP
Two posts: BOTTOM
Align cut part in protective ring with notch
in thermal insulator top.
Barrel housing direction
As shown below, position notch
in thermal insulator top so that it
is at center of top right two screw
holes (* in figure) on barrel
housing.
Note : Align the notch of
the insulator as shown
right.
Note : Open the cut part in
the protective ring and set
it.