Furuno SCX-20, Operator'S Manual

Page: 23 / 86

1. INSTALLATION
1-13
7. Remove hex socket head bolts one by one and
fasten the supplied screws with adhesive loosely.
After loosely fastening four screws, fasten them
tightly then wipe off the excess adhesive.
Note: The adhesive takes approximately 30 min-
utes to adhere.
8. Connect the NMEA 2000 antenna cable to the
bottom of the antenna unit.
9. Secure the antenna unit with the supplied three M5 screws from the underside.
10. Loosen the hex socket head bolts (see
step 5) with the supplied hex key wrench
then adjust the direction of antenna base so
the bow mark on its base is facing the ship’s
bow. After adjusting, tighten the hex socket
head bolts on the antenna base again.
Antenna base
Set screw
(four places)
Antenna
unit
Screws (three places)
Bow mark