2. HOW TO SETUP THE MENU
12
Dimensions/
CCRP
Enter the appropriate value according to the ship’s size,
to improve the accuracy
of the 3-axis speed
. The reference position for mounting position and calculating po-
sition of the 3-axis speed are shown in the following figure:
Equipment
Identification
Not used. This menu item is grayed out.
-
Ship’s Width
Set the ship’s width, calculated from the
port-side to starboard-side of the widest
section of the vessel.
1.0 to 999.9 m
Ship’s Length
Set the ship’s length, calculated to the
bow-tip to the stern, along the center of
the vessel.
1.0 to 999.9 m
Ship’s Height
Set the ship’s height, calculated to the
bottom of the keel to the top of the mast.
1.0 to 199.9 m
ANT Position X0
Set the port-starboard (Lateral) position
of the SATELLITE COMPASS
™
. Enter
negative value for port-side, positive
value for starboard-side. The center of
the vessel is “0”.
Depends on the
ship’s width.
ANT Position Y0
Set the bow-stern (Longitudinal) posi-
tion of the SATELLITE COMPASS
™
.
Set the distance from the bow to the
stern with the bow as 0 m.
Depends on the
ship’s length.
ANT Position Z0
Set height of the SATELLITE COM-
PASS
™
, from the bottom of the ship.
Depends on the
ship’s height.
CALC-SPD-POSN Y1
Set the bow-stern position for calculat-
ing the 3-axis speed. Ship’s speed can
be measured at two locations in addi-
tion to the antenna position. Enter the
backward distance from the reference
position (Fwd Center of the bow) to the
position where you want to measure the
ship’s speed. Normally, enter the bow
position (Y1) and stern position (Y2).
Note:
In the default setting, Y1 and Y2
are entered as follows:
• Y1: 0 m (bow position)
• Y2: 10 m (10 m backward from bow
position)
Depends on the
ship’s length.
CALC-SPD-POSN Y2
Menu Item
Remarks
Setting range
Reference
position
(0.0)
Ship’s width
Ship’s length
X (+)
X (-)
Y (+)
Ship’s height
Ship’s length
Ship’s hull line
Reference
position
(0.0)
Y (+)
Z (+)
Draft position
