3
Note:
The Yanmar VC10 system
must
have an
ID Key (Yanmar supply)
in advance to
activate the communications with an autopilot.
Wiring the IF-NMEA2K2 to EVC
Connect the
NMEA2000 connector (Micro-C, male)
of IF-NMEA2K2 to the bus of the
Yanmar VC10 network.
Wiring the IF-NMEA2K2 to the NAVpilot-711C (TB7)
Connect
NMEA0183 wires
of IF-NMEA2K2 to the processor unit F
AP-7002
:
TB7
(NMEA0183 Port 2)
ports as shown below. Make sure that the IF-NMEA2K2 conversion
mode is set to
High Speed mode
by modifying the remaining wires in order to
communicate in 38,400 bps.
Connection with TB7 (NMEA
port 2)
Connect the signal lines of the
cable to TB7 with the color
assignment shown at right.
Pin No
Signal
Color
1
TD_A
L-BLU/YEL
2
TD_B
L-BLU/GRN
3
RD_H
PNK
4
RD_C
PNK/BLK
5
Shielded
DRAIN
