Furuno GP-1650WDF, Installation & Maintenance

Page: 11 / 74

1. INSTALLATION
1-3
Flush mount
Pan head screws
216
±
1
164
±
0.5
4.5
6-R2.25
132
±
0.5
125
±1
Flush mounting of display unit
1.2 Installation of Antenna Unit (GP-1650WDF only)
Mounting considerations
Install the antenna unit referring to the installation diagram on page D-3 or D-4. When
selecting a mounting location for the antenna unit, keep in mind the following points:
•
Select a location out of the radar beam. The radar beam will obstruct or prevent reception
of the GPS satellite signal.
•
The location should be well away from a VHF antenna. A GPS receiver is interfered by a
harmonic wave of a VHF antenna.
•
There should be no interfering object within the line-of-sight to the satellites. Objects
within line-of-sight to a satellite, for example, a mast, may block reception or prolong
acquisition time.
•
Mount the antenna unit as high as possible. Mounting the antenna unit as high as
possible keeps it free of interfering objects and water spray, which can interrupt reception
of GPS satellite signal if the water freezes.
•
Do not shorten the antenna cable.
•
If the antenna cable is to be passed through a hole which is not large enough to pass the
connector, you may unfasten the connector with a needle nose pliers and 3/8-inch
open-end wrench. Refasten it as shown in the figure below after running the cable
through the hole.
Center pin (soldered)
Clamp nut
Connector shell
Gasket (reddish brown) Washer
Shield
How to assemble the connector