Furuno GP-1640F, Operator'S Manual, Page: 79 / 108

11-11
UPLOAD/DOWNLOAD DATA menu
This menu allows you to upload waypoint and
route data to a PC or download the same data
from a PC, via the DGPS connector at the
back of display unit. The menu can be
displayed by pressing the [MENU] key followed
by the CONFIGURATION and
UPLOAD/DOWNLOAD DATA soft keys. For
detailed information, see the installation
manual.
For memory card, see chapter 10.
DWNLOAD
UPLOAD
DGPS 3D
DOWNLOAD WPT/RTE TO PC
UPLOAD WPT/RTE FROM PC
RETURN
SAVE DATA TO MEMORY CARD
LOAD DATA FROM MEMORY CARD
Upload/download menu
ANT XDR DGPS NMEA
13GND
2
12-24
VDC
-
+
Connect PC to DGPS.
Display unit, rear view
Set communication software on the PC as
follows:
Baud Rate:
4800 bps
Character Length: 8 bit
Stop bit: 1 bit
Parity: None
X Control:
XON/XOFF
The following data can be
downloaded/uploaded between a personal
computer and this equipment.
•
Waypoint data (In alphanumeric order)
•
Route data (In order of route number)
•
End of sentence
Note 1:
There are two kinds of data for route
data: route data and route comment
data.
Note 2:
DGPS position fix is not available when
uploading or downloading data.
Download waypoint/route to PC
1. Connect the PC to the equipment as shown
on the next page.
2. Press the DOWNLOAD WPT/RTE TO PC
soft key. You are asked if you are ready to
download waypoints and routes.
3. Press the [ENTER] key to download.