Furuno FS-5070, Installation Manual

Page: 43 / 84

3-5
3.4 System Setup
Enter system settings as below after the installation. To prevent accidental transmission of
the distress alert, disconnect the antenna. These settings should be entered by a qualified
technician. The installer enters system settings on the System Setup menu. A password is
required to access this menu. Under no circumstances shall the operator access the
System Setup menu.
3.4.1 Opening the System Setup menu
1. Press SETUP key to display the Setup menu.
2. Rotate ENTER knob to select “SYS SETUP”.
3. Enter the password referring to appropriate FURUNO INFORMATION to display the
System setup menu. The password cannot be informed customers by statute.
System Setup
EQUIPMENT TYPE : 5070
PROTECTION : OFF
DSC SYSTEM SETUP
RT SYSTEM SETUP
LOAD DEFAULT
TEST
System setup menu
3.4.2 DSC SYSTEM menu
Choose “DSC SYSTEM SETUP” on the System setup menu, and then press the ENTER
knob to show the DSC System setup menu.
DSC System setup
MMSI: xxxxxxxxx FIXED
MODEM OUT
: 3.0
dBm
SIG DET S LEVEL : 100
REGULATION : INTL
CLASS : MF/HF
DIST : PANEL1
2006-04-01 00:00:00
DSC System Setup menu
MODEM OUT
Adjust the level of the modem output for DSP board (DSC modem, NBDP modem).
Normally, this setting is not required.
SIG DET S LEVEL
SIG DET S LEVEL judges whether the DSC frequency to use to send a DSC message is in
use or not. The DSC message is not transmitted when the signal strength on the DSC
frequency is higher than that set here. When the DSC frequency becomes clear, the DSC
message is automatically transmitted. The setting range is OFF - 255 and the default setting
is 100.