STEP 1
Use either a 19mm or 3/4" wrench to remove the 3 hydraulic
fittings from the top of the HRP Pump and discard. Five new
fittings are provided with the hardware kit.
STEP 2
Insert the 3 "O" rings from the hardware kit into the round recesses in the bottom of
the FPS-8 Power Steering Module. Apply a small amount of hydraulic fluid to the “O”
rings to hold them in place. Carefully assemble and tighten allen screws evenly,
ensuring that the o-rings are not pinched!!
Pre-Attachment Preparation
WARNING!!!
It is critical that this conversion only be performed on a
VERY CLEAN
work surface!
DIRT, DUST AND/OR OTHER CONTAMINANTS WILL DAMAGE THE PUMP AND
CAUSE IT TO FAIL!!!
WARNING!!!
It is critical that this conversion only be performed on a
VERY CLEAN
work surface!
DIRT, DUST AND/OR OTHER CONTAMINANTS WILL DAMAGE THE PUMP AND
CAUSE IT TO FAIL!!!
See compatible pump
models listed above
