Furuno FPS8 Installation Information Download Page 3

Page: 3 / 6

STEP 3

STEP 4

Align the 3 bolt holes in FPS-8 Power Steering Module with the 3 threaded

holes in the HRP Pump housing.

Screw in the 3 Allen-head bolts from the hardware pack. Tighten them

evenly with a 3/16" Allen wrench.

Insert the 5 hydraulic fittings from the hardware pack into the 5 threaded holes in the FPS-8 Power

Steering Module.
Please see the FPS-8 Installation Manual for more information regarding the hydraulic connections.

Make sure the "O" rings remain in place and do
not fall out or get pinched during assembly.

Connect wires per instructions in the

NavPilot 700 Installation Manual

Pump / motor wires to

TB2 in NavPilot

Processor

FPS-8 Sensor wires to

TB5 in Navpilot

Processor

Attaching the FPS8 to the HRP Pump

Summary of Contents for FPS8

Page 4: ...Hydraulic Diagram Single Helm Single Ram NavPilot HRP Pump with FPS8 Power Steering Module HELM CYLINDER A STARBOARD HELM TANK PORT STARBOARD PORT STARBOARD PORT ...

Page 5: ...l plug Lower Helm Station must have a non vented fill plug UPPER HELM B LOWER NavPilot HRP Pump with FPS8 Power Steering Module HELM A CYLINDER B CYLINDER A PORT PORT PORT PORT STARBOARD STARBOARD HELM TANK S T A R B O A R D STARBOARD STARBOARD PORT STARBOARD HELM TANK HELM TANK PORT ...

Page 6: ...wer Input Power Input TB4 TB3 TB10 TB11 TB12 TB6 TB7 TB2 TB1 TB2 TB1 12 24 VDC INPUT NavPilot 700 711 720 Processor FAP 7002 TB13 TB8 To TB5 Each of the sensor cables has the same 3 wires It does not matter which set of 3 go to pins 1 2 3 or 4 5 6 It only matters that the order of the wires are as follows Check out the collection of marine electronics navigation we offer ...