Furuno FE-800, Operator'S Manual

Page: 25 / 60

1. OPERATION
16
3. Select [DEPTH(BELOW)] using  or  , then press the ENT key. This will open a pop-up.
4. Select the location to take the depth reading from, then press ENT to apply the settings and
close the pop-up window. The available options are [Transducer], [Surface] and [Keel].
5. Press the MENU/ESC key twice to close the menu.
1.16 How to Set Draught
Draught is the calculated distance from the keel to the water surface. Draught can be set in two
locations, [FORE] and [AFT], if your vessel has transducers at both of these locations. If your ves-
sel only has one transducer, the draught is set at the transducer
location only.
To set the draught for your vessel, do the following:
1. Press the MENU/ESC key to open the Main menu.
2. Select [Sounder] using

or

, the press the ENT key.
3. Select the appropriate transceiver to set ([FE-8020 No.1]
or [FE-8020 No.2]), then press the ENT key.
4. Select [Draught], then press the ENT key. This will open a
pop-up window.
5. If using a single transducer configuration, skip to step 8.
For dual transducer configuration go to the next step.
6. Select [AFT] using

or

.
7. Choose the draught depth using

or

, then press the ENT to select [FORE].
8. Adjust [FORE] draught using

or

, then press the ENT key to apply the settings and close
the pop-up window. Available range differs according to the setting of keel in [Service Menu].
When the setting of keel is set as 0.0 m, the available range is 0.0 m to 30.0 m. When the
setting of keel is set as 10.0 m, the available range is 10.0 m to 40.0 m.
9. Press the MENU/ESC key three times to close the menu.
Draught between the External Equipment
When [EXT Setting] in the [System] menu is set to [ON], the draft value is taken from external
equipment. When [EXT Setting] is set to [OFF], the draught value is as set in the above procedure.
The FORE/AFT bar is absent in
single transducer configurations.