11
3.2.2 How to enter transducer data by transducer specifications
(manual setting)
To connect the transducers which are not programmed, do as follows:
Note:
The transducers of 53 - 65 kHz, 111 to 139 kHz and 171 - 183 kHz cannot be connected to
the FCV-295 because of noise.
1. At the XDCR Setting dialog box, select "XDCR Select" and press the
ENTER
key.
The following screen appears.
2. Press
T
to select "Manual", and then press the
ENTER
key.
3. If a high frequency transducer is fitted, press
T
to select "HF Connection" and then press the
ENTER
key.
4. Press
S
to select "Connected" and then press the
ENTER
key.
5. Press
T
to select "Freq" and then press the
ENTER
key.
6. Press
T
or
S
to set the frequency of the transducer which is connected and then press the
ENTER
key.
7. Press
T
to select "Band width" and then press the
ENTER
key.
8. Press
T
or
S
to set the value for the bandwidth and then press the
ENTER
key. If the band-
width is not entered manually, it is automatically set to 1/10 of the transducer frequency.
9. If a low frequency transducer is fitted, repeat steps 3 to 8.
Note:
Leave the "Tx Power" at "Auto".
10.Press and hold down the [
/BRILL
] key to turn off the power.
CAUTION
CAUTION
When you install the transducer whose
type is programmed, DO NOT select
“Manual” on the XDCR setting dialog box.
Wrong transducer setting can damage the
transducer and void the warranty.
XDCR Type
Manual
Connected
Not connected
--- kHz
Summary of Contents for FCV-295
